Lab GI5-10
Simulating the Circuit With Two Gates and a D Flip-Flop From GH27-13
20 points

OEES 235

Back to Main Page

 

  1. Click the green Start button and check to be sure you're logged in as Adminelab.
  2. Get into ispLever Classic Project Navigator.
  3. Click File, New, Project
  4. Use GI5_10 as the project name
  5. At the right of the Location box is a button with three dots. Click this button.
  6. Find your folder (in My Documents, your floppy, or flash drive) and single click-it.
  7. Click the Make New Folder button.
  8. Name the new folder GI5_10 and then click OK.
  9. In the Design Entry Type box, choose Schematic/ABEL.
  10. Click Next
  11. In the Family box, choose ispLEVER Default Device.
  12. Click Next.
  13. When the Add Source window comes up, click Next.
  14. Click Finish.
  15. Click Source, Import.
  16. Find the schematic file (ending in .sch) you created for lab GH27-13 and double click it.
  17. In the Sources in Project window, single click the schematic file.
  18. In the Processes for Current Source window, double click Compile Schematic.
  19. When the Report Viewer window comes up, make sure it doesn't show any errors, and then shut it down.
  20. Download the ABEL test vector file by right-clicking this link: GI5_10.abv 
  21. Put this test vector file into the folder containing the other files for this experiment.
  22. In the Sources in Project window, single click the device name (LC4256ZC-45T100C).
  23. Click Source, Import and double click GI5-10.abv.
  24. In the Sources in Project window, single click GI5-10.abv.
  25. In the Processes for Current Source window, double click Functional Simulation.
  26. In the Simulator Control Panel window, check to be sure there were no errors.
  27. Click the red exclamation mark to run the simulation.
  28. Check the waveforms to be sure the circuit operated correctly.
 
Back to Main Page
1